PDA

View Full Version : Need help installing JDM DC2 Type R steering wheel


WhiteGsrBeater
02-13-2008, 07:32 PM
Alright everyone I installed the JDM DC2 Type R wheel non-srs onto my 96 GSR sedan. I took off all the srs stuff.

My horn doesnt work. How do I fix this?

mob182
02-13-2008, 07:40 PM
Here you go

Click (http://honda-tech.com/zerothread/1875083)

WhiteGsrBeater
02-13-2008, 09:19 PM
Here you go

Click (http://honda-tech.com/zerothread/1875083)

Wrong write up, that is a SRS wheel that plugs up to the stock stuff. The one I have is a NON-SRS... It does utilize the SRS harness.

Thanks though

WhiteGsrBeater
02-14-2008, 01:54 AM
Anyone???

Spody02
02-14-2008, 02:18 AM
no but my horn dosent work either...
so just use the finger
it works better =]

WhiteGsrBeater
02-14-2008, 02:22 AM
I like that too...

ixcocoyxi
02-14-2008, 02:25 AM
i have an aftermarket steering wheel and i couldnt find a way to use the horn.. so im just gonna install a button for the horn somewhere.. maybe on the armrest or near the ignition for the key..

Spody02
02-14-2008, 02:31 AM
steps to properly giving someone the finger...

1. drop the hammer
2. get in front of them
3. open sunroof
4. finger out the top

WhiteGsrBeater
02-14-2008, 02:35 AM
I like getting in front of them then brake checking then the finger

ixcocoyxi
02-14-2008, 02:43 AM
for people that know.. i throw batteries..

Spody02
02-14-2008, 02:52 AM
haha
didnt you say that in another theard?

ixcocoyxi
02-14-2008, 02:54 AM
in a nutshell.. yeah.. lol!

superchi
02-15-2008, 02:03 AM
Alright everyone I installed the JDM DC2 Type R wheel non-srs onto my 96 GSR sedan. I took off all the srs stuff.

My horn doesnt work. How do I fix this?

http://www.honda-tech.com/zerothread?id=1887852%20%3Cbr%3E

Here's the how-to I used to install my Momo steering wheel, the wiring process is written for NRG or other aftermarket steering wheels, but the ITR non-SRS wheel should be the same idea. The back of the steering wheel has a metal plate, so you'll need to fasten a metal contact that will touch the wheel when installed (make sure to use some lubricant on the plate), and then run a wire from the metal plug to one of the pins in the SRS plug since the ground for the horn is pinned into that plug. Feel free to test out each pin, you'll know which one it is when the horn goes off. PRO TIP: I used a piece of 14ga wire wrapped around a paper clip as my metal contact *GHETTO* but it has worked without fail.

ixcocoyxi
02-15-2008, 02:14 AM
after reading that.. i'd like to hook mine up now.. LOL!!