I found some Riken wheels for really cheap on Craigslist & the wheels size is 15X8 which is what im looking for, only problem is the wheels bolt pattern is 4x114.3 which sucks. So what do you guys think about the bolt pattern conversion? Is it safe? Will the wheels fit? BTW im goin to roll the fenders
IMO not worth it, specially for what the adapters go for
BTW not sure what wheels u are looking at but i bet it will prob look mexi flush
BUT as far as the adapters being safe, if installed correctly yes!
i have some on the rear of my jimmy to make up for the difference in axles(front/back) and they have been fine for over 5yrs(with stock wheels and tires, aswell as with 24in wheels that weigh 80lbs each)
to install them right u clean up the hub on the car of any corrosion and then put the adapter on, alittle lock right on the studs and tighten it right up, MAKE SURE TO TORQUE IT! then just bolt on your wheel like normal, and torque again, drive it a few days and check the torque on everything
NOT SURE isnt there a honda out there where u can change the whole hub assembly on, to end up with that 4x114.3 bolt pattern on your car?