That was copy + pasted. I already read that. I'm looking for a good DIY with pictures.1. Begin by disconnecting the negative battery cable. Relieve the pressure in the fuel system and drain the cooling system.
2. Disconnect the air intake duct, the water bypass hose, the cables to the throttle and cruise control, the brake booster hose and the evaporative emission (EVAP) hose. Label the hoses as they're disconnected
3. Remove the intake manifold cover and the strut brace. Loosen the intake manifold nuts and bolts. Start in the center and move outward while working in a criss-cross pattern. Remove the nuts and bolts.
4. Check and disconnect all vacuum hoses. Lift out the intake manifold and throttle body as a single unit.
5. Inspect the intake manifold carefully for any damage or cracks. Replace any parts that are damaged.
Not really. I was hoping to find a nice DIY with actual pictures, not diagrams.thing for skunk2, dunno if it'll help you or not...
http://www.skunk2.com/installation/307-05-0280.pdf
i know this is a old thread. but i will try my best to write one DIY with pictures. i will be taking it apart and putting it together tomorrow. hope this will help some people in the future.Can anyone link me to a good DIY with pictures?
It needs to come completely out. I need to replace the intake manifold gasket, clean the FITV, and repaint it while its out. I tried looking on TI and Honda-Tech, was having a hard time finding a good thread on it.
Did you ever get around to it? Thanksi know this is a old thread. but i will try my best to write one DIY with pictures. i will be taking it apart and putting it together tomorrow. hope this will help some people in the future.