atomic_peach
New Member
I've had my Python 991 installed for a while and the alarm works perfectly fine, except for the remote start. I can get it to start the remote start (you have to turn it on before locking it in order to use it later) but when I get out of the car and lock it, it produces an error and shuts the car down. I haven't seen any parking light errors (5+ flashes) and the remote doesn't state any errors either. I do notice, however, that when I activate the remote start (before locking it) the car shows that the doors are "open" for about a second, but then "close" again.
I did manage to get MTS mode activated a few times (meaning I can use remote start) but when I try to start it later, nothing happens and an error kicks back. ow I cannot even get MTS activated.
Is there an issue with my alarm brain or is it my wiring? Is there anyone around central PA that can test this with a spare alarm brain? Any help would be greatly appreciated.
Thanks
-atomix
I did manage to get MTS mode activated a few times (meaning I can use remote start) but when I try to start it later, nothing happens and an error kicks back. ow I cannot even get MTS activated.
Is there an issue with my alarm brain or is it my wiring? Is there anyone around central PA that can test this with a spare alarm brain? Any help would be greatly appreciated.
Thanks
-atomix