tony19950725
New Member
Im in need of help, the screw of my turn signal housing got stripped and the housing fell out while I was driving so close to my house and before I could stop in time I ran over the whole housing. I was able to recover the large turn signal connector, however the parking light connector cable got ripped out. Im not sure how to re-wire the turn signal and also the parking light connector to the wire harness.
The parking light connector has the red power cable attached and glued in but the length of the broken off cable is only 5 inch. However, the ground (black) cable I don't know how to fit it back in.
Does anyone know how to reconnect the ground cable back into the socket?
Thanks
The parking light connector has the red power cable attached and glued in but the length of the broken off cable is only 5 inch. However, the ground (black) cable I don't know how to fit it back in.
Does anyone know how to reconnect the ground cable back into the socket?
Thanks