how to install exhaust

importknight

New Member
ok now i need help on how to install my exhaust is there anything online to show me how, and what do i need, i have the jack, i got rust desolver i got the pyrimid things that go under the frame (forgot what there called ) umm and i got a ton of wrenchs and sockets what else do i need.
 

k624ash

New Member
you need stands to hold the car up. All you have to do is undo some bolts, slide the old exhaust of the hangars, put the hangars on the new exhaust and bolt it up. the bolts might be hard to undo though, spray them down good with some pb blaster, like go out and do it a lot for a couple days before you try and change it. air tools are nice.
 

g2teg

save a whore..buy a porno
air tools cut the time in half, but you dont get the full effect of busted knuckles, i say wrench away
 

nexgenintegra

1ac4u2nv
a sawzall works very very well and a dremel, no air tools, no busted knuckles. Also get some Never-Seez, forgot who makes it but you can probably get it at home depot. you can apply this to all bolts and fiber gaskets, so if you gotta take it apart in 5 years you will have not one problem takin off the bolts.
 


TegSox

Super Duper Moderator
Yeah, by far the most difficult part of putting on an exhaust is getting the old bolts off the old one. Besides that, it's a piece of cake. Do as much pre-soaking of the bolts with some PB Bolt Blaster as you can. Whack off as much rust as you can with a hammer too, then soak them, but sometimes even doing all that is no good. The bolt heads can be so rusted away that they turn to powder when you even try to put a socket on them. You may need to have them cut off, air tools ARE nice. :)

"the pyrimid things that go under the frame ". Those are jack stands, I believe. :lol:
 
Top