1990 Acura Integra won't start, ls

Da9Specs

New Member
my integra wont start. no CEL light everything works. but when i turn it on to crank it everything dies out... i need help!
 

Merlins Beard

*Beard not included
Is your battery charged up? What does it do when you try to start it? We need more information than "everything dies out" to give you an accurate cause.
 

djzachtyler

Looking for my next Teg..
Check your grounds... ALL OF THEM

ALso check that the negative battery post clamp is not loose or over worn...

Grounds to check will be negative cable to top of transmission, cable from valve cover to radiator support, and also the small black clip wire to the top of the starter, & the groud from the engine block to the front of the car.

My money ois on the negative battery cable. I had the same issue & all grounds looked good, but the issue was fixed by actually replacing the damn terminal clamp on the negative cable...
 

RS01

New Member
Black corrosion is especially bad. Do not spare the sandpaper or steel wool when cleaning the terminals. This corrosion is hard to see but it can stop the voltage from flowing.
 


Top