g6qwerty
Member
I was Just having some fun in the mountains and well my engine started knocking, loud at anything above 2,000rpm.
II believe it may be a bearing because I put in about 3/4 of qt of tranny fluid that I had in my trunk and another 3 qt of 20w-50 from the gas station and drove it home under 2000rpm and it sounded a little bit worse on the last 1mile.
It has a Stock B20B on the motor, so would just ordering parts for a 1997 honda CRV's B20Z or B20Z1 work for these parts?
engine bearings
connecting Rod bearings
pistons and rings
connecting rods
I may replace the Oil pump too but as I remember from last time I researched it, a stock integra's oil pump will work fine. Hopefully the cylinder head is fine where the camshafts ride.
I'll Let you know what I find once I open up my engine, might be 1-3 days depending on how soon I can get the garage cleaned out or find something else. Won't Order any parts till I find out what is wrong.
II believe it may be a bearing because I put in about 3/4 of qt of tranny fluid that I had in my trunk and another 3 qt of 20w-50 from the gas station and drove it home under 2000rpm and it sounded a little bit worse on the last 1mile.
It has a Stock B20B on the motor, so would just ordering parts for a 1997 honda CRV's B20Z or B20Z1 work for these parts?
engine bearings
connecting Rod bearings
pistons and rings
connecting rods
I may replace the Oil pump too but as I remember from last time I researched it, a stock integra's oil pump will work fine. Hopefully the cylinder head is fine where the camshafts ride.
I'll Let you know what I find once I open up my engine, might be 1-3 days depending on how soon I can get the garage cleaned out or find something else. Won't Order any parts till I find out what is wrong.