89 ef obd1 converted b18a1 ~trouble starting~

luckyjdm

New Member
When we first swapped it we started it and the water pump was leaking the only codes we were getting at that time was 41 ( o2 sensor ) which we havent wired up yet.

Then we changed the water pump and timing belt and the car started up fine again drove it around but it felt like it was a tooth off no low end power.

Took off the timing belt again and we were off a tooth now it is set correctly on timing and the car will not start. Getting spark ( used the tool that goes on the spark plug wire to check ) and fuel, compression is 180 across the board. What could it possibly be? We were getting a check engine light for intake air tempature sensor. Went and got a new sensor and now the only code is 41. We were thinking maybe the main relay changed that and it wasnt it either. The car wanted to start but it seem hesitant and it wouldnt.

Any ideas of what to check for? I checked all the fuses all the wiring for the obd1 conversion and checked for power to all the wires everything is good. Im really mind boggled by this one.
 
Top