I did the swap about four years ago but I had the manual car rite next to each other it was kinda easy
but the wiring wa sthe only problem.
1.take out the dash.
2.take out the trans
3flywheel,clutch,cable
3.drill hole 1 3/4 we're cable should go but remove auto ecu first.
4.install pedals .oh good luck its a bit hard.
5.install shift likage ,but use energy supension bushings it feels better.and try to put a rubber boot from shifter to car or it gets kinda load inside.
6.ecu from auto works but will give you several codes,try to get manual ecu.
7.the most important one is the electric cable left over from auto trans shifter REMEMBER you need to be in park or neutral to start car those wires must be together to trick the ECU .
8.enjoy.