Auto to manual Transmission swap?

lancegre13

New Member
:twisted:So I have an automatic 93 integra, and I am wanting to drop a manual trans into it. I want find out in addition to the transmission, and clutch what I need to change out, and how much it will cost? Is it worth it?
 

nismodrifterx

New Member
its a hard conversion if you dont know what your doing, never done it myself but seen how people have done it,

need
ecu (manual trans)
clutch cable
whole pedal assemble
shift linkage
new flywheel bolts
flywheel
as well as some cutting and electrical modifications
probly forgetting some stuff
unless its a special car doesnt seem worth it, you can pick up a five speed teggy for next to nothing these days
 

integration718

New Member
I did the swap about four years ago but I had the manual car rite next to each other it was kinda easy
but the wiring wa sthe only problem.

1.take out the dash.
2.take out the trans
3flywheel,clutch,cable
3.drill hole 1 3/4 we're cable should go but remove auto ecu first.
4.install pedals .oh good luck its a bit hard.
5.install shift likage ,but use energy supension bushings it feels better.and try to put a rubber boot from shifter to car or it gets kinda load inside.
6.ecu from auto works but will give you several codes,try to get manual ecu.
7.the most important one is the electric cable left over from auto trans shifter REMEMBER you need to be in park or neutral to start car those wires must be together to trick the ECU .
8.enjoy.
 
Top