91 da w/ jdm b16 obd1

[boostedninja]

ok i have a obd1 b16 with a jdm ys1 tranny i got from a site. fuckers sent me a obd1 instead of obd0 ..lol... more power tho. i used the old b18 harness for the b16 and it all wired up great. but my friend was telling me that a obd1 motor wont start in my 91 integra. i have a pwo ecu, i also still have to run vtec and others.. is my car going to start up or do i have to do more wiring?

 

[DAs_an_DCs]

i have a b16a DA too, its obd0 tho. the main differences are the distributor and the ECU. if you wanna use your PW0 ecu for your B16 then you can wire it up obd0 with your factory harness and a vtec subharness from rywire or just add the 4 wires yourself (you have to wires with pin clips at the ECU side tho). but you will HAVE to get the OBDO distributor.

 

[BrokenTalon27]

Easiest solution: get a Rywire jumper harness, a socketed and chipped p28, and an OBD1 distributor, then get to wiring.

 

[g2teg]

Easiest solution: get a Rywire jumper harness, a socketed and chipped p28, and an OBD1 distributor, then get to wiring.

x2