Black Widow Kit, turn signals?

Billabonguy

New Member
Simple noob question, I just picked up a 93 integra and got a deal on a full black widow body kit. the only problem is that theres no holes or spaces for the turn signals.

what are my options?? i was just wondering if i could buy a whole assembly to just have the blinkers with my headlights or do i have to just cut holes? thanks :)
 

Mildsquare

From the bay to LV
you have a couple of options, one is to cut up your turn signal and to mount it to the bumper support, or just mount it to your bumper support somehow or another to is to mount the light onto the back of one of the openings close enough to emit light, only thing bad about this is it's exposed to rain and other road debris. If you have a mesh kit covering the openings, it will give some protection but not much. Is the kit Fiberglass Or Polyurethane? IF fiberglass don't get it, those kits are really weak and will break with the slightest tap of the bumper. A buddy of mine had 94 integra with a bw kit and some one barley tapped his rear bumper and it cracked like a California fault.
 

Billabonguy

New Member
the dual filament bulb, does that mean my turn signals will be in the same assembly as my headlights like most cars??? cuz if that were possible, THAT would be perfect.
 


Billabonguy

New Member
oh yeah and its a fiberglass kit. my friends are telling me to just cut holes for the turn signals, but if its possible i'd rather not.
 

g2teg

save a whore..buy a porno
best bet is to expand the hole where they would normally go and seal the whole thing around the light with silcone so try and kee p the water out and make sure that they wont fall out either
 
You must log in or register to reply here.
Top