screwed up corner (running light on driver side) after using resistor.

[rayray88]

screwed up corner (running light on driver side) after using resistor.

Basically this is what happened.

I was getting the usual rapid turn signals after installing some LED's for my corner lights and blinkers.

I bought some resistors and i wired the two grounds together with the resistor.

and screwed up by running the power wire from the corner light with one of the power wires from the turn signal

and i basically figured that I didnt even need to run the resistor with the corner light at all, only with the turn signal light.....

and now the light from the screwed up corner light (driver side) stays on even after the key isnt in the ignition.

im kind of lost as to how to fix it because the grounds and the power wires are connected to the turn signal anymore.

any ideas?

 

[DonJulio]

You blew a fuse.

Return back to oem and if it's fixed.

Research proper led wiring.

If I were you could just added a flasher delaying relay. That should calm the LEDs down.

 

[rayray88]

Anyone else have any suggestions? Problem still exists....