Auto Integra Stalls when given gas in any gear but park

LilFiendTegy

New Member
just put my head back on my b18b1 an the car starts up everytime fine, its got a fluctuating idle cold an warm, its not super low or high, just wont stay in the same place for more than a minute, I can rev it up in park an it gets air an gas just fine but the moment I put it into reverse or drive the gas pedal disappers an it drops to like 300-400 rpm, giving it gas results in the car slowly bogging down an stalling out. letting it idle in gear it will kinda roll at 300 rpm.
I checked the trans dipstick an its full with fluid, I replaced the torque converter in it but I made sure to fill it with the proper fluid before installation.
Im not throwing any CEL an the D4 light isnt flashing.
could it be one of the sensors on the transmission like the vss or lock up gone bad? or anyone have any other input? Ive got a fuel gauge on my filter an fuel is fine, it revs fine in park. its once I switch gears it become a dying engine.
stock ecu its all stock b18b1
 
Top