bad_biddy
New Member
New to the site - Currently swapping my Integra from a LS to a built GSR block / b16 head turbo setup.
This is my first motor swap on the Integra and I want to make sure I got everything right before putting the intake manifold.
Question #1
I bought a used / new Rywire Vtec subharness. I have some questions on installing it. There are three plugs and a ring terminal setup. Two of the plugs go to the vtec solenoid. I assume the ring terminal is for a ground. I think the last plug is for a GSR IAB setup but since I wont be using IAB's I can disregard the plug.... I just didnt know if it needed to be plugged in to complete the circuit.
Here is a picture of the plugs/wires in question.
The plug not plugged in is this one:
Question #2
I removed some misc items from the LS to GSR swap..... I can't remember what plugs into these fuel lines....
Here is some pics of the lines in question:
This is my first motor swap on the Integra and I want to make sure I got everything right before putting the intake manifold.
Question #1
I bought a used / new Rywire Vtec subharness. I have some questions on installing it. There are three plugs and a ring terminal setup. Two of the plugs go to the vtec solenoid. I assume the ring terminal is for a ground. I think the last plug is for a GSR IAB setup but since I wont be using IAB's I can disregard the plug.... I just didnt know if it needed to be plugged in to complete the circuit.
Here is a picture of the plugs/wires in question.
The plug not plugged in is this one:
Question #2
I removed some misc items from the LS to GSR swap..... I can't remember what plugs into these fuel lines....
Here is some pics of the lines in question:
Last edited: