Mike's 2000 dc4

MiketheDyke

My job is clean toilets
I waited so long to buy an Integra 2dr. and here it is! Owning a coupe was my dream and I finally fulfilled it :woot:

So here's a little information about my new teg 8)

2000 Acura Integra LS with 138,000 miles. I am currently the 3rd owner. His asking price was $6000, but I bought it for $3900 :D

Specs:

Propulsion:
- Stock B18b1
- AEM SRI
- Apexi N1 exhaust
- Magnaflow High-flow cat

Drivetrain:
- Exedy OE clutch kit
- Rebuilt transmission

Exterior:
- Rear wiper delete
- OEM ITR wing from Japan ;)
- OEM window visors
- OEM mudflaps
- Shaved side moldings
- OEM sidemarkers
- OEM EDM rear fog
- JDM power-folding mirrors
- aftermarket antenna
- Honda emblems
- Replica ITR front lip

Interior:
- JDM Non-SRS ITR steering wheel
- Skunk2 Shift Knob
- Pioneer In-dash
- Custom horn switch in dash

Suspension:
- Koni Yellows Struts
- Ground Control sleeves
- Skunk2 lower control arms
- Skunk2 camber kits
- ASR subframe brace
- ASR 24mm sway bar (rear)
- 26mm sway bar (front)
- Beaks lower tie bar
- Buddy Club P1 Extended Ball Joints
- USDM Type R 5-lug nut conversion
- Password:JDM 3 pt. front upper sway bar


Wheels/tires
- Runway 205/55/16
- RSX Type S wheels

Security
- Viper alarm system



Now for the pics: (THE FRONT BUMPER LOOKS WAY BETTER IN PERSON THAN IN THE PICTURE)

















Most recent







 
Last edited:

R13

The other asshole


Moar low, Itr wing, Lip and paint that valve cover :thumbs up

Jk do whatever you like, Nice whip!
 


R13

The other asshole
:thumbs up Hope the fitment on that wing turns out good, Also when drilling the holes... Measure once, Measure twice and just when you think the measurements are good, Measure again. :lol:
 

MiketheDyke

My job is clean toilets
:thumbs up Hope the fitment on that wing turns out good, Also when drilling the holes... Measure once, Measure twice and just when you think the measurements are good, Measure again. :lol:
What do you mean fitment? Will the replica be longer, shorter, etc?

Or should I just waste the $50 more to buy an OEM one? lol
 

R13

The other asshole
Oem is always better, Replica fitment can be hit or miss, Some fit some don't, Some change shape over time, Oem will likely have a smoother surface and is guaranteed to fit, I would send the money to Tom and let him or Skygun get you an oem because let's face it, Wouldn't it feel nice knowing in the back of your head every time you take a glance at the wing that it's an Oem type r wing?

Eh?

 

R13

The other asshole
You could get them cheaper from CA Might have to wait a bit for one to pop up and you still would have to pay for shipping (Would only be like $30-$40) but to answer your question that can be fixed so if you wanted to you could get it all the same, Just make sure it's for sure oem.
 


Top