ScrewDriver
New Member
I am currently replacing my head gasket, set it at TDC before hand and than took everything off replaced gasket not an issue there. I put the head back on bolt it down put the rocker arms on (I mixed them all up because at the time I didn’t realize they needed to go back to the exact same spot, I know I’m an idiot for that.) so I put them back in and than cams, than bolted everything down made sure to loosen my rocker arms as much as possible so they won’t be damaged when bolting the cams down, made sure it was all correct as far as Intake and exhaust. When I try to line my cams back up they don’t and need to slant otherwise they press down on the rocker arms. Now I can’t get the timing to be right as when I try to spin the crank it doesn’t line back up. Long story short my cams don’t sit back up right when putting them back in and I can figure out the timing. If anyone is willing or could help please let me know where I’m going wrong. B18A1 motor