ibam
New Member
ok so here is my set up
1990 integra ls
stock b18
bolt on turbo kit( 8 lbs)
converted to from obd0 to obd1 ecu ( starts and idle fine and reves fine in neutral)
up graded injectors to 440cc
has stock fuel pump and regulator.
the ecu was tuned online and shipped to me based on my set up, it is set up for the obd1 o2 sensor
however I haven't wired the 02 sensor yet, can this be the cause?
so when I drive it and step in it has little power and probably hits only 3500 rpm, but if I slowly open the trotle it will gradually increase.
can the fuel pressure or pump be the cause?
1990 integra ls
stock b18
bolt on turbo kit( 8 lbs)
converted to from obd0 to obd1 ecu ( starts and idle fine and reves fine in neutral)
up graded injectors to 440cc
has stock fuel pump and regulator.
the ecu was tuned online and shipped to me based on my set up, it is set up for the obd1 o2 sensor
however I haven't wired the 02 sensor yet, can this be the cause?
so when I drive it and step in it has little power and probably hits only 3500 rpm, but if I slowly open the trotle it will gradually increase.
can the fuel pressure or pump be the cause?