Anywhere I can get a cheap bore

[integra_mjh]

Am looking to bore and sleeve my block but i been having some problems for parts and places to do it...... Any suggestions...... Am also going through lik a quart of oil every week & half, some one hd told me i had bad valve stems..... any other suggestions.

 

[j13]

Your engine needs to be rebuilt. Their is no cheap way. You either pay up and do it, or you don't.

If its a basic B18B1 you could buy one cheap, for around $600 ready to swap. if I ever need serous engine work, that's the option ill take.

 

[DB7xsjado]

yeah with some shit like that I'd just get rid of that motor

 

[pluckt007]

i would go to tj if i was looking for a cheap "bore" haha.

 

[Samurai_Blue]

boring is cheap its like $7 a cylinder and to hone it is like $6 the supporting mods are what are expensive

 

[wite2nr]

sleeving services cost around 800-1k+ and come with any bore you request. Its best to provide the pistons with the block to get the tolerances within spec.

 

[integra_mjh]

thanx i was planning on rebuilding it anyway am going boost so i want to build the bottom end stronger