Auto to manual swap?

99TegLs

Senior Member
check out my build thread. There's a lot of little stuff. Any questions, feel free to PM me.
 

99TegLs

Senior Member
well sir. I actually made money off of my swap haha. Let me break it down for you!
The parts I had:
1. 1996 4 door 5 speed integra
From that car I had everything I needed for the swap and more. I picked it up for 500 dollars.
From there I sold the Engine for 350 dollars, the seats for 150 dollars, and the rear disc conversion for 200 dollars.
I also sold the trunk for 85, the doors (all 4) for 250 dollars. Therefore if you total it all up:
I made 535 dollars.
THE PARTS YOU WILL NEED IF YOU DONT BUY A WHOLE CAR INCLUDE:
1. Transmission (most likely an s80)
2. A shift linkage appropriate to our cars.
3. A clutch and pressure plate
4. slave master cylinder and resivoir (complete with full clutch lines
5. slave cylinder
6. Auto to manual conversion mounts (rear t bracket, front tranny mount, and a special mount you have to order from Hasport)
7. Manual intermediate shaft
8. shift knob/boot
9. p75-A02 manual ecu.
All of that separately adds up very quickly.
Hope this all helped, and rep up if it did!
 

ishavedmyballs!

I have no lunch money
I'll take your word for it. I'm just scared I'll ruin my car
 


Top