Teg4u
New Member
I just picked up a da with a b20b turbo. I got it with a bad headgasket so I just finished putting on the gasket an started it and it started. But the problem is that when I give it gas it will rev it then the revs will come down and the car will shut off. I can rev it very lightly and it won't die but if I push more then 1/4 on the pedal then it will die
it's running a chipped ecu. Had been dynotuned on program Crome
so if it's chipped that means ignition timing is already set.
We checked the cam timing twice and everything is on mark
injectors are rc 440's
the car supposedly ran before the headgasket
there is a little pipe on top of the throttle body that isn't hooked up but it didn't make a differance when we cover it up
any help please cause i need this car running
it's running a chipped ecu. Had been dynotuned on program Crome
so if it's chipped that means ignition timing is already set.
We checked the cam timing twice and everything is on mark
injectors are rc 440's
the car supposedly ran before the headgasket
there is a little pipe on top of the throttle body that isn't hooked up but it didn't make a differance when we cover it up
any help please cause i need this car running