1lowda9
New Member
So heres the deal I have a 90 da b18a1 I pulled the whole motor to do some overhaul on it replaced
head gasket
Skunk2 70 mm throttle body
skunk2 70mm intake manifold
aem fuel rail
dc short ram intake
fidanza 7 pound fly wheel
xct stage 3 clutch
ry wire ground kit
relocated the map sensor to the throttle body
main relay
ignition wires
ngk iridium spark plugs
mishimoto radiator
accel 8mm spark plug wires
adjusted valves
set tdc
IM OUT OF ANY IDEAS now heres the issue the car gets spark the car gets fuel the grounds are all the good the main relay and ignition wires are all brand new its holding 150 on all four cylinders when tested the car cranks and cranks but will not turn over ive ran thru the harness numerouse times and its all connected correctly tried four different main relays change the firing order done the tdc five times done litteraly everything shy of pulling the whole motor out and putting it back to stock im out of ideas as to why it wont start any help would be amazing thank you
head gasket
Skunk2 70 mm throttle body
skunk2 70mm intake manifold
aem fuel rail
dc short ram intake
fidanza 7 pound fly wheel
xct stage 3 clutch
ry wire ground kit
relocated the map sensor to the throttle body
main relay
ignition wires
ngk iridium spark plugs
mishimoto radiator
accel 8mm spark plug wires
adjusted valves
set tdc
IM OUT OF ANY IDEAS now heres the issue the car gets spark the car gets fuel the grounds are all the good the main relay and ignition wires are all brand new its holding 150 on all four cylinders when tested the car cranks and cranks but will not turn over ive ran thru the harness numerouse times and its all connected correctly tried four different main relays change the firing order done the tdc five times done litteraly everything shy of pulling the whole motor out and putting it back to stock im out of ideas as to why it wont start any help would be amazing thank you