Darton Style Sleeves & CP Pistons Picture

[Antx]

Sleeved Block B18A2

Pistons & Rods installed

"Darton Style" Sleeves
CP Pistons 81.5mm comp. 9:1
Eagle rods

I'm gonna install the B16A2 Vtec Head with ARP studs in a few days..

 

[Aussie]

That should hold a good bit of boost.

 

[Antx]

That's what I'm thinking of..
Where should I stop
20 psi maybe..

 

[Joshmmc]

Turbo LS/V @ 20 PSI ? I'm on board.

 

[sps21112]

Did you take my advise? And i think those sleeves are proven up to 50psi on race gas so 20 would be safe.

 

[Antx]

I took the advice. Regards..

I think of running on 97 octane pump gas which is found common here..

 

[sps21112]

It really depends on the tuner and his abilities when it comes to how much boost it will take and how good your fuel setup is. Good luck keep pictures coming!

 

[Antx]

here's my manifold and turbo :

 

[Prozon]

Where did you get the sleeves?

 

[Antx]

A factory in Turkey makes them for B-Series and D-Series..

 

[sps21112]

Thats a big ass turbo! Nice!!!

 

[Antx]

sps21112 : the sleeves are not 84mm because there was a problem with the 84mm pistons I couldn't get them, there was CP 81.5mm so I got them for a very good price. So the project has become 81.5mm.

I also had to use 81mm gasket with the 81.5mm bore, I think there's no problem. right ?