zack11122
New Member
Ok so today I did my valve cover gasket and distributor O-Ring. I went to put everything back together. I am pretty sure i didnt get the tabs into the camshaft. Dont ask how. I dont know either. So I went to start my car and it wouldnt. I forgot to plug it in. So I plugged the dizzy in and then no start. Pulled the dizzy back off and put it back on right this time. Started up normal. But I had 3 codes. Secondary o2 sensor, running lean, and my ELD high input. I cleared the codes then went to drive. I had no power. My car would barely accelerate. It was kind of like limp mode. Now would this most likely be the distributor? Or should I replace my fuse box?
