Help w/ Clip that hold speed sensor cable to tranny frm cluster

562Thomas

New Member
Can anyone help me by telling me how to put this clip back on it hold the cable in place were speed sensor wire cable meets the tranny it comes from cluster





It has sort of a curve or groove on one side and the little tube it clips on to has a slit were it it goes into if anyone can just pull the rubber boot off of theres and tell me wich way it goes it would be dope thanks in advance...
 

BrokenTalon27

W.F.O
Just use your needle nose pliers to bend it in slightly to keep it snug. Pull back the rubber boot, slide on the clip, put the boot back over it.
 


You must log in or register to reply here.
Top