How to adjust your throttle cable?

Suprman91

"Zip-Tie-It!" - Wisdom
Sup guys, I was reading how to install a 3pt. strut bar, and it said you had to disconnect your throttle cable to you can fit it properly. It also said it's not recommended if you dont know how to adjust it. Got any advice?
 

Prozon

Kris
There's two nuts. The position of the nuts is how it's adjusted. Basically just make the cable tight and adjust the nuts so they tighten down on the little tab it fits into.
 

RED Integra

New Member
Sorry but bumping this, I adjusted it recently because I kept stalling well almost stalling. It's tighter now but I think it's too tight, I'm idling at a bit above 2000 rpm tho. I need a "perfect" number thanks
 
You must log in or register to reply here.
Top