I think I've found my ABS problem

[GSRIntegra]

To keep things short, here's a picture of what I'm dealing with


IMG_20110811_202400 by MEGAHURTZ5934, on Flickr

Look like it was cut and then taped back together. :what:

Could this be an easy fix by soldering a new wire connecting the two pieces? If so, what guage wire do I need?

or

Would I need to buy the whole driver side rear wheel ABS wiring?

 

[mjones73]

Some 16 gauge wire, some heat shrink to seal it up and some soldering and you should probably be ok.

 

[GSRIntegra]

That's what I figured, but I don't know d*ck about the electrical aspect of a vehicle. Time to read up.

Any other opinions?

 

[Samurai_Blue]

get another abs wire

 

[jdmjim]

yea, its part of the whole sensor $150.oo

 

[j13]

Get a new sensor.

..off topic, nice sway..I want a gsr rear sway bar so bad..freaking DC4 is a thin wire sway bar

 

[GSRIntegra]

Thanks. I'll sell you mine once I find out what hardware is needed to install a USDM ITR rear sway on a GS-R.