New Valve Cover Paint Job!

[DB2Teg_Boy]

Opinions are welcome! Good nd Bad!

The picture doesn't do it justice. It actually looks better in person. It's an ionized Blue with a clear coat on top!
Mind you this was done with sand paper nd two cans of spray paint so don't be that hard on me. No Homo! Lol

 

[treeafodo]

Looks pretty good. Are you going to sand the letters down?

 

[8-bit]

should post a pic when installed.

 

[DB2Teg_Boy]

Looks pretty good. Are you going to sand the letters down?

Yes sir!! I did last nite before I painted it so it would be easier today. Lol

 

[DB2Teg_Boy]

should post a pic when installed.

Will do itz that my whole engine is dismantled right now. Need to put the new block with the new head back on then trans nd then in she goes. Lol

 

[DB2Teg_Boy]

Looks pretty good. Are you going to sand the letters down?

Here's a pic with the letters shaved treeafodo.

 

[teggyboi59]

Did u put high temp paint or wat kind?

 

[treeafodo]

Here's a pic with the letters shaved treeafodo.

The pic isn't showing up. Might be tapatalk though.

 

[DB2Teg_Boy]

Did u put high temp paint or wat kind?

Sure did!!

 

[DB2Teg_Boy]

The pic isn't showing up. Might be tapatalk though.

Okayy immature try nd upload again!

 

[DB2Teg_Boy]

 

[92gsrboy]

looks good

 

[Visionnaire]

That looks nicer with the polished letters. Like that blue too!!

 

[DB2Teg_Boy]

looks good

Thank You!

 

[DB2Teg_Boy]

That looks nicer with the polished letters. Like that blue too!!

Thank You! Yeah i think so too. Wasnt the Blue that i was lookin for but it Came out OK!!