Paolo's VSM integra build

paoloDa92

New Member
I have a set of the rep lights on the car and but I used the OEM wires and button. The OEM lights are literally brand new (never mounted) never used.

Sent from my SAMSUNG-SM-N900A using Tapatalk
 


paoloDa92

New Member
Update:
Not much has changed but I recently started collecting parts for my JDM front end conversion. So far I have about 80% of the parts I need for the conversion.

Things I have
-core support
-fenders with side markers and pigtails
-headlights with hid and ballast

I just need a hood and a bumper and I'll be able to do the conversion!

I wasn't going to do the conversion but I bought those parts for dirt cheap, $300 for everything. Couldn't pass that up.
 

paoloDa92

New Member
As many of you know (if you're following my insta) you would know that I recently hydrolocked my engine that caused a hole in my block.




Been car less for about a month

7/8/14 bought a b20 from foreign engines for 916.75 shipped to my door
7/9/14 at 10:15 am motor was delivered and dropped off at the door (great service and super fast shipping)



Motor came with a new oil pump and seals.

Parts for the new motor
-gates timing belt
-new water pump
-oil pump gasket
-Rear/main seal
-Valve cover gaskets
Total: $221.88
-oe clutch $130.98
-flywheel resurfaced $44.00

my buddy works at napa and I get homie discount lol




7/13
Pulled the motor out and started swapping parts over.






You can see the hole on the block
One in the front and one in the back lol





Well when removing the transmission found out that clutch and flywheel is toast. Lol

Replaced it with oe spec and flywheel is resurfaced.



Small garage/ workspace lol



new motor with parts swapped over except tranny and dizzy and some parts







That's day 1. Decided to stop for tonight and continue it and finish it tomorrow.
 
Last edited:

97 teg

New Member
Sorry to hear that. Didn't know. Whats your insta?

Nice work getting the b20 going, and dang that was some fast delivery lol
 
Top