dannyseps New Member Jul 26, 2013 #1 I changed the pump and the main relay and stil the pump won't prime. I put the key to in and the engine light will stay on, is it not sopose to turn off after a few seconds?
I changed the pump and the main relay and stil the pump won't prime. I put the key to in and the engine light will stay on, is it not sopose to turn off after a few seconds?
randomhobo automagic user Jul 26, 2013 #4 ground wire on thermostat housing... had the same issue after a motor swap.
dannyseps New Member Jul 26, 2013 #5 randomhobo said: ground wire on thermostat housing... had the same issue after a motor swap. Click to expand... Ill check that out , and post after
randomhobo said: ground wire on thermostat housing... had the same issue after a motor swap. Click to expand... Ill check that out , and post after
dannyseps New Member Jul 28, 2013 #6 I cleaned the three main grounds and I also added a ground from the battery to the frame.... No luck
TheIVJackal Freedom through Jesus Jul 28, 2013 #7 Did you check the fuel pump fuse under the dash? - Aaron
dannyseps New Member Jul 28, 2013 #8 TheIVJackal said: Did you check the fuel pump fuse under the dash? - Aaron Click to expand... I know about the relay but not a fuse, where is it I went through the fuse box and I didn't see anything That said fuel pump.
TheIVJackal said: Did you check the fuel pump fuse under the dash? - Aaron Click to expand... I know about the relay but not a fuse, where is it I went through the fuse box and I didn't see anything That said fuel pump.
djzachtyler Looking for my next Teg.. Jul 31, 2013 #9 check all the fuses if you have to and do not forget about the fuse box under the hood as well. Sounds like you may still have a relay issue tho.
check all the fuses if you have to and do not forget about the fuse box under the hood as well. Sounds like you may still have a relay issue tho.