question on my lsvtec build

[dateg88]

Ok so I have a question regarding the block that I'm building for my lsvtec. I wanna make sure that what I have will work and if it seems to be able to handle what I'm going to run it on.
ok its a b18b1 block
golden eagle sleeves bored to 84mm (1.9 liter)
arias 9.5:1 forged pistons
Eagle h beams (gsr) ****
ls crank micropolished knifed and balanced
arp rod bolts
ACL race bearings
gsr water pump
Itr oil pump +squiters

What I was a little confused about was if my rods and crank would work in my block. This my main concern. I'm planning on running 15psi on this block just wanna make sure it would be reliable. Any input would be great.

 

[jsp413]

sounds good i might get a gsr block girdle or aftermarket one
here is one off ebay http://cgi.ebay.com/ebaymotors/KMS-Engine-Block-Girdle-B16-B18-B20-LS-VTEC-dowel-pins-/350472578489?pt=Motors_Car_Truck_Parts_Accessories&hash=item5199cb25b9#ht_1647wt_958

 

[Aussie]

Gsr and ls rods are not the same length. Your looking at adding 2.8mm of extra stroke to the gsr rods. I'm pretty sure this would push the pistons over the deck, unless you get custom ones.

 

[dateg88]

Ok just a quick update I actually have a gsr crank not a ls so that should be good also got a gsr girdle. Ant input on my setup would be great. Good bad things I should add etc etc. I know its my build but I have so much running through my head rite now I might be overlooking or forgetting something