rebuild?

[el_tigre]

how much is to rebuild ls block,,,,i know you guys know, this is my firt time and i don't have any idea

 

[thenoxus1]

Pistons 2-400. Hone walls-100-200 depending on place. Probably want a valve job. 350. Oem gaskets etc - 200. Labor 1000-2000 depending on rates etc.

 

[el_tigre]

dammmm,is better buy b20 motro with low miles?

 

[thenoxus1]

Depends on your money and goals. A lot of people will buy swaps because it's cheaper. I wanted more
Power so I upgraded when I rebuilt mine with higher end stuff. But that's pretty expensive.

 

[Samurai_Blue]

costed me about 200 to rebuild my block by myself.

It all comes down to your power goals etc.

 

[el_tigre]

Depends on your money and goals. A lot of people will buy swaps because it's cheaper. I wanted more
Power so I upgraded when I rebuilt mine with higher end stuff. But that's pretty expensive.

yeah to get more power that way is better...

 

[el_tigre]

costed me about 200 to rebuild my block by myself.

It all comes down to your power goals etc.

that's cheap bro...

 

[thenoxus1]

He did the labor himself mostly, and went with a lot of oem stuff for parts too. Depends on what you buy.

 

[el_tigre]

thats rigth all depend what you want on it !!!!!

 

[Samurai_Blue]

my bottom block consisted of the following:
acl race bearings
acl main bearings
acl thrust washers
arp rod bolts
arp arp main studs
balanced rotating assembaly
npr rings
pr3 pistsons

actlally i think it was about 500-700 i forgot i think i paid 100 alone to balance the crank


but it depends if you want a ls build or a vtec build

 

[el_tigre]

well that is good price,,,the think is when you have to paid the labor that is expensive

 

[Samurai_Blue]

helms manual is your friend if you are inexperienced

 

[Samurai_Blue]

a b20 swap is over all cheaper

 

[el_tigre]

yeah that's rigth i have to get one

 

[Samurai_Blue]

i would find a low mile one and not the b20b so you dont have to wire up the knock sensor