white89hatch
New Member
If my Integra is throwing a code for tps do i need to replace it or should I try to calibrate it first?
TPS question.
- Thread starter white89hatch
- Start date
endo617
Rattle Can Technician
calibrate it first, what code is it exactly though?
white89hatch
New Member
Its throwing code 7 and code 41. Which i believe is tps and o2 sensor
white89hatch
New Member
So i calibrated the TPS its at .50 ohms but it still throwing code for tps sensor what is wrong with my car someone please help. It's started to piss me off.
endo617
Rattle Can Technician
when you were calibrating the TPS did the numbers increase and lower from .1 to .9 if it didn't then the TPS has low voltage and need to be replaced
white89hatch
New Member
I believe it did. I had to adjust it from .58 to .50. Then i turned the throttle to WOT and it was at 5.48 ohms i believe.
BrokenTalon27
W.F.O
white89hatch
New Member
Man this sucks. I'll go home and adjust it and see what happens.
white89hatch
New Member
Yea i saw that video. He does his in test in ohms.
white89hatch
New Member
Purchased a TPS today hope this fixes it.
BrokenTalon27
W.F.O
I'm aware of that. I've set TPS's with his method before that worked just fine.
white89hatch
New Member
I wasn't saying you were wrong. i just didn't understand why someone told me i was wrong when i said i measured mine in ohms.
mjones73
New Member
You want it higher then .50 if you're using Ohms. The .50 is for when you're measure voltage with the tps plugged in and the car on. The value isn't the same for both methods.
One thread I found recommended 1.01 ohms at closed throttle. That video had the sensor at .85 stock and recommended .5 to .9. I'd have to dig more to find a solid number to use.
One thread I found recommended 1.01 ohms at closed throttle. That video had the sensor at .85 stock and recommended .5 to .9. I'd have to dig more to find a solid number to use.