Vaccum Lines?

[Andrew93]

Ok so i got my new b18b in replacing the old b18a...not the intake manifolds i have do not have the lines in the same place as the old ones, so im trying to figure out which line goes where....ill post some pics of it personally but this one has the same setup as the new one.

 

[jdmjim]

well you have your brake booster, pcv valve and fuel press reg. they should be in a similar location

 

[Andrew93]

The b18a vacuum linees are on the side by the filtermand piping.... the b18b has them in the front of the manifold. ill put pics up tomorrow i put the axles in today hooked up the exhaust after i traded the manifolds, put my radiator in and wire it most the way.

 

[Andrew93]

ok so this is the old intake from the b18a

some lines under the backside
here is the new one on the B18B

basically i dont know which of these hoses go where

 

[acclude]

well, to make it incredibly simple for you, vacuum is vacuum.

As long as they all connect to the IM it doesn't matter where they're connected. I think the Blox IM has fewer connections so you might have to use a few T fittings to tie them all into vacuum, but again, doesn't matter where they go as long as they're connected.

 

[guiltyxxspark]

acclude's got it. Vacuum is vacuum.