how would i wire these?

[Ganyon]

So I got my light strips. Upon observation, I have no idea how to power these. There's just 4 little pegs at the end of them. Wtf.

 

[DeAngebro]

Cole would know! I'll tell him to look at this.

 

[klutchDb7]

Those look like they should plug in to some sort of a controller or receiver unit, did you check to make sure it didn't require one when you got it?

 

[Ganyon]

Yeah and they are different in the picture. I did some searching last night and I need these.
http://www.amazon.com/gp/product/B0058S1Z80/ref=ox_sc_act_title_1?ie=UTF8&smid=A3UYUTM4BYYNKB
I kinda like the design.

 

[XjoEnX]

Where did you order those? My friend used the same type to light up the back of his television for a home theater. I'll ask him about it too.

 

[Ganyon]

Got them from amazon. 8 bucks for all 4.

 

[Physh1]

Mine came with pigtail connectors to wire them up. 2 of those pins are + & two are negative. May need to test them with 12v power to figure out which is which. Good thing is, on most of those strips, wiring them backwards won't burn anything out so test until you're id'd the pins.

Cameron

 

[Ganyon]

I tested them and they didn't light up, but I was using a d battery which is probably 5 years old.

 

[XjoEnX]

I asked my friend and his only has two wires. Sorry bro.

 

[Ganyon]

It's all good. I ordered the connector for them, so I can wire them up.