Search results

This my Integra (B18B swap) which was my first car and I truly loved it. Fast forward a year later and a new path opened up as a financial advisor so the teggy had to go:cry:. Currently driving a G35. :D

is it a difficulkt task to put a whole new harness i ecause there is A LOT of wiring under the dash also the engine is swapped with a b18b (previous owner)

Hey guys so i got a new ignition switch installed and and my radio and blower motor stopped working. So i replaced the 40 amp fuse it was blown) and my blower motor starts working again but not my radio(radio fuse for some reason has no power at all like both terminals of the use have no power...

lol ur right about tht ahx thx i guess i will.l

hey everyone so my car has a problem (lol not surprised). The temperature gauge reads c even after 20+ min driving but it will start blowing hot air after 5m idle. I don't know if this is a thermostat problem or temp gauge /////// on a side-note ive had the car for 1 year and have never once...

yea it does have an alarm your probably right thx alot!

yup

ok sorry for the really late reply i got very busy and looked at the car yesterday and i started to unscrew ignition switch screws but then i noticed that there was a wire(stripped both ends) and it was attached to a white and a yellow wire and i put my key in ignition and messed around with the...

hey there is one its called 2nd gen integra club (i hav a second gen lol)

i can hear clicks and fuel priming and wires and plugs are good i guess it just might be the ignition switch.

hey guys so i was driving and usually if i hit a pot hole the car would turn off. well now the car doesnt start at all unless i hold the key in the on position but not too far or it will make that screeching sound. If i let go key it will not stay running so does this mean it is an ignition...

Sorry about posting the read twice my phone lagged can a mod delete the other one

Hi guys I've searched and every picture and diagram I've found for this vaccum line has the 2 connected where they should be just like mine but then one of them is connected like near the map sensor but I looked and can't find anywhere to plug it in. My engine is a b18b can anyone help me find...

lol no they are thick 3/8 bolts and yes i hand tightened (i meant with a ratchet) anyways i fixed it now i am 100% sure it wont fall off now and ill make sure to bleed the brakes again thanks all for help.

okay so i had bled mine like this (left front,right front,right rear, left rear) do i HAVE to rebleed them? and also i hand tightened them yesterday and drove it today after about 2 hours total driving time my rear caliper fell off again! the 2 bolts that hold the whole caliper assembly on. i...

okay so when my brake pedal sunk what happened was that my caliper had actually fallen off and it felt like my brakes went but really it was all the juice goin to the caliper and closing the gap that was made after it fell off the rotor. Wow i look,ed at the bolt in it and its threads were like...

okay so i recently changed my front driver side brake caliper and also my rear brake pads. I was driving today and i pushed in the brake and the pedal hit the floor so i slowly pulled my ebrake and jsut barly stopped else i would of hit the car infront of me then i pump the brake pedal and for...

lol^

what do you guys suggest (brands) for a non abs da (1991)

not nice to rice