slickdevil08
New Member
Ok so heres what im dealing with. just swaped a fully rebuilt jdm b20b into my integra. used the same b18b1 ecu and it shifts fine and everything starts up great and seems fine at first however as soon as i get it out of the garage. i can literally hold down the gas pedal and the rpms go nowhere until a few 5 seconds later they start to allow some throttle but its super hard to get moving. i checked for cels and got these:
3 Map Sensor
10 Intake Air Temperature
7 Throttle Angle
54 Crankshaft Speed Fluctuation Sensor
i saw that the map sensor and throttle angle lights came on and i replaced the throttle body with my old b18b1 throttle body which had no issues. however when tryed it again it was the same result and same codes.
i also believe that its okay to have the 54 since the jdm motors dont have that sensor and it should change anything to mess with performance.
please help me find this issue.
thanks all!
3 Map Sensor
10 Intake Air Temperature
7 Throttle Angle
54 Crankshaft Speed Fluctuation Sensor
i saw that the map sensor and throttle angle lights came on and i replaced the throttle body with my old b18b1 throttle body which had no issues. however when tryed it again it was the same result and same codes.
i also believe that its okay to have the 54 since the jdm motors dont have that sensor and it should change anything to mess with performance.
please help me find this issue.
thanks all!