reg_lus
New Member
after my fresh rebuild, approximate 40 miles so far.
d16z6
i didn't feel any vtec lift when it engages or anything. supposedly 4600rpm or close there.
just didnt feel like there's any lift at all? i dont think this is normal because
when we did my brother's single cam rebuild, it pulls harder when vtec engages.
(i wasn't near redline or anything, just up to 5500 rpm)
any clues?
d16z6
i didn't feel any vtec lift when it engages or anything. supposedly 4600rpm or close there.
just didnt feel like there's any lift at all? i dont think this is normal because
when we did my brother's single cam rebuild, it pulls harder when vtec engages.
(i wasn't near redline or anything, just up to 5500 rpm)
any clues?