Lo Key
New Member
I'm on a serious timeline, I need my car to be ready and on the road by the first. I recently bought a b18c RHD front clip. I switched the motor out, and the ECU (which I bought the OBD2B to OBD2A jumper harness from RyWire).
I dropped in the motor, and I can't for the life of my figure out where three of the plugs coming from my USDM harness hook up to on the motor. That's one problem.
The other is, I tried to turn over the motor before I noticed the above problem. When I did, it was wanting to start, it just seemed starved for fuel. Once I found this out I went to the parts store to rent a NOID light check thing to see if my injectors are even getting power. They aren't...and I don't know why.
I've checked every fuse under the dash, and nothing is blown...any ideas?
I dropped in the motor, and I can't for the life of my figure out where three of the plugs coming from my USDM harness hook up to on the motor. That's one problem.
The other is, I tried to turn over the motor before I noticed the above problem. When I did, it was wanting to start, it just seemed starved for fuel. Once I found this out I went to the parts store to rent a NOID light check thing to see if my injectors are even getting power. They aren't...and I don't know why.
I've checked every fuse under the dash, and nothing is blown...any ideas?