Intercooler fitment

[AlphaWolf1993]

I bought a generic b series intercooler piping kit, I have a mishimoto Z line. The piping fits fine and would be the right fit for most setups except for one small issue. The turbo sits far too low for a straight coupler and 90 pipe. I'm looking for some input on fixing this. I was thinking of using a 45 reducing coupler, or cutting the pipe off the turbo and the connecting pipe to the ic and making a single pipe that sweeps downward... I can't get the pipe to go straight back, only at a huge angle.

Please help!

 

[Muckman]

ideas

1. tilt the driver side IC pipe downward
2. use a 90* coupler
3. use more elbows to make it work

 

[AlphaWolf1993]

Ok, I wasn't sure if a 90 coupler would be too tight or a nono. I'm really new and trying to get it all set, but my setup came out a little odd

 

[AlphaWolf1993]

Thank you for always being the words of wisdom.

 

[xxBLOOD88SHOTxx]

90 to a short pipe with a 45.