AlphaWolf1993
New Member
So I purchased this mani and turbo a while back, they've been run before so I know they can work. However, the measurements on the flanges are slightly different. The bolt holes line up, but the gasket my kit sent fits poorly as such:
Turbo: I didn't have gasket quite centered, but it has a small sliver on left/right sides that show
Mani: has a noticeable amount of flange showing. I've measured both and neither fit t3 or t4 measurements (was told it's a t3t4 but can't find a measurment for them). I just don't know what I should do. I'm worried this gasket will just allow air to blow past the gasket since it doesn't seal evenly on both sides... Please help