Search results

Any one know for track days if a good Stock Radiator (Performance Radiator) would be sufficient for a B20B that is run on a stock ECU? Not buying a radiator from Orielys, it was way to easy to put a hole in it when installing the A/C condenser fan. I did test the car for a cylinder headgasket...

Bought a luk clutch kit and the pressure plate is missing a bolt hole in the center of each group of 3 bolts so it only has 6 of 9 bolts holding the pressure plate on. Is it alright to use when it's missing those bolts?

I have been looking for the bushings for the rear lower control arms. All I can find is the Strut to arm bushings. I need to find the bushings that go to the car and to the kunckle. Shown as #22 , with oem part# 52365-SK7-A02 in the link below...

I was Just having some fun in the mountains and well my engine started knocking, loud at anything above 2,000rpm. II believe it may be a bearing because I put in about 3/4 of qt of tranny fluid that I had in my trunk and another 3 qt of 20w-50 from the gas station and drove it home under...

Any one have any recommendations for alignment parts? This is just for stock ride height. Budget ~$100 - $250 I need camber and castor in the front and camber for the rear. The front right has been hit on a curb x2 and it bent the upper control arm mounts, so I had to hit them back with a...

Abs Modulator/Unit leaking how to fix? I've always had a slow brake fluid leak in my integra and now its gotten even worse, and can quite clearly see it leaking from a hole / plug on the drivers side in the rear above one of the brake lines there, is their anyway to plug a leak from there? Now...

Any body know were to find a 1 1/2in or smaller eletric oil pressure gauge with a black face and analog display? I was going to put it inside a 90 integra instrument cluster and don't want to bother with having oil line getting broken when putting it all back together. Or perhaps a duel Oil...

I've noticed over the past years I've driven my car, that it will have a High pitch whine that sounds like its coming from where the ECM sits in the floor boards. It tends to do it at high rpms and gets louder as the engine revs up. Also seams to get louder when I have the heater on, Runing...

Dose anyone have any reference pictures of the wiring to the engine and starter? I took some pictures at the junkyard but It didn't dawn on me to take further out pictures. My car was missing all the wiring mounting brackets that went to the transmission, and thermostat housing and also missing...

Complete wiring diagrams I found, it don't show location, but it has everything even the abs wiring which the haynes manual didn't have and much nicer to look at, though you have to print it out and tape 3 pages together to get a really nice view. Works Just Download the Part 1, Part 2 and...

I have a 90 Acura Integra With JDM one piece plastic headlights and fog lights, but i can't fit a H3 bulb in to my fogs lights its just falls in to the hole because the hole is too big. The H3's don't fit in my fog lamp spot. they just fall inside and if i close up the holder they just rattle...

I do have bigger tires on it 205-55-R16 though it is still reading way to high. It happened right after i fixed the car when it died on me, and was hunting all around for the sorce of no spark, and then found out it was the Ignitor, so i replaced it with one from a 95ish Honda Accord distributor...