MSP611
New Member
hey guys i have a ys1 tranny (b20b swap) with i think is the stock b18a clutch cable set-up.... wat the problem is, is tht i replaced the clutch becuz i was getting a chattering noise... it ended up being the backing tht holds the springs on the clutch disk was broken off and flopping around in there. Now before i changed the clutch (not just for the noise) i was having trouble getting it into gear... like the clutch wasnt disengaging or engaging at all...
looked at the clutch cable adjustment and it was tightened all the way to the very bottom almost to the very last thread tht you can adjust it to... when i depress the clutch it seems like im not pulling the linakge arm enough up to press the throw out bearing into the fingers of the pressure plate to disengage the clutch...
here's my real question, should i go buy a new clutch cable 90-93? or is there another honda/acura clutch cable tht is shorter in length already tht i can use
looked at the clutch cable adjustment and it was tightened all the way to the very bottom almost to the very last thread tht you can adjust it to... when i depress the clutch it seems like im not pulling the linakge arm enough up to press the throw out bearing into the fingers of the pressure plate to disengage the clutch...
here's my real question, should i go buy a new clutch cable 90-93? or is there another honda/acura clutch cable tht is shorter in length already tht i can use