roycehep
New Member
So i just recently bought a 91 GS. After putting exhaust and cv axles in it, it is now drivable and i am having some fun in it. I have it really low.. haha like really... low. Its pretty funny. im pretty sure that because it is so low, my cv axles are just strait up binding lol. I want to raise it up a little to save them but i like the slammed look. I probably am going to lift it up a little bit because it vibrates pretty good during hard accel.
So. Skip to it. I was wondering if there are any fairly simple, yet rewarding ways of taking the head off of an engine that has vtech. Then install it onto the block of my engine (B18A1). I know i will have to wire in the vtech solenoid and probably use a different ECU, but i was wondering what engine i should be looking to take the head off of or what head i should be looking for.
THANKS!!
So. Skip to it. I was wondering if there are any fairly simple, yet rewarding ways of taking the head off of an engine that has vtech. Then install it onto the block of my engine (B18A1). I know i will have to wire in the vtech solenoid and probably use a different ECU, but i was wondering what engine i should be looking to take the head off of or what head i should be looking for.
THANKS!!