Search results

Ok so on my way home from work a Subaru decides to run a stop sign so I swerved to miss them and hit a hill which caused me to flip so since I just have liability and they ran from the seen I gotta fix it out of my pocket do you guys thinks its worth it I have a brand new rebuilt motor That runs...

i have an auto transmission with only 9k and upgraded limited slip disks will fit 90-93 integra if interested send me an offer

ok so i rebuilt my motor and dropped a dowel pin out of the head so i put it all back together and it ran ok for 550 miles then started flooding cylinders with oil/coolent so i took my head off put back in dowel pin put in new head gasket and it started right up do you think that dowel not being...

my car was running prfectly fine but after i parked it for a couple hours and got back in to drive it starts right up but wont rev over 3250 rpms it goes up like normal but just stops at 3250 rpm what the hell happened?

ok so i was driving home last night and my lights just turned off and i flipped them off then on and they came on but really dim like they were barely on and the lights would get bright and go dim over bumps do you think its a ground or crossed wire? if so were at? i did work on it before and i...

i rebuilt my engine and it started right up but the idle bounces do you think it could be those nobs behind the intake manifold? i think i moved one a few times well i was rebuilding

can someone give me a list of all the bolts i need to torque and to what torque?

before taking my engine apart it turned really smooth but now its really hard to turn after putting in the new bearings is that normal does it just need to break in? or am i doing something wrong? the bearings are all stock sizes and definitly match up with the old bearings

help how the heck do i get the pin out that holds timing belt crank pulley i tried to pry it out carefully but i dont wanna break anything and i cant seem to grab it with pliers any ideas at all on how i can get it out?

So I got a b18b head and put it on to find out my block is warped so should I take it to the shop to get milled or should I take all my new pistons and rings and put it in my old block but I would wanna change the girdle too but the only reason I just don't do it is Because I don't know if the...

Hi guys please help me out I've been working on my teg engine and after rebuilding the head putting a new head gasket and didleak down test to prove the rings were good but I continue to have bad compression and don't know why is it maybe the timing? My compression is 35 (for 1) 40 (for 2) 48...

Hey there I need help setting my timing I can't seem to do it right Because I can't start my car but I got close but I can use some directions to setting the timing its a 2nd Gen integra b18a1 engine and head

Hi guys my integra just died the battery is good everything is powered and sounds Like It wants to start but wont turn over thinking bad fuel pump or filter but don't know please help I need my baby on the road

Hi there I just pulled a b18a1 out of a race car and I'm gonna drop it in my 90 teggy ls my question is can this engine be vtec? The Guy I bought it from said it has 9,000 miles on it and it has a c1 type r head but everything looks stock to me could it be built from the inside out to make it...

Can anybody help me? I Wanna know how to make the auto ecu manual or would it be easier to pull the chip out and put it in my manual ecu?