Search results

I could barely read it once...less 5 times... But I think what he is saying is that he wants to know what to do with his car to make it better all-round. :)

jack it up, take off right tire, inspect the boot if its torn...and give the joint a shake...

It means you won't be able to connect the rear lower sway bar. You can still drive without the sway bar (just disconnect it for now and drive gently) and go get the adjustable end link when you have time. The reason why it doesn't fit is because there is no pre-drilled hole on the Blox LCA...

hello night mod :) always had my eyes on the BC P1's but the F91 just has sharper racing lines that I think match the DC2 :twisted:

Buddy Club F91's matt black...15x7...mmm... Where can I get a set. :) (looks like a 16 or 17 in the pic below...but w/e)

About the "button"...are you referring to the horn?

If you were buying a muffler off ebay, not so bad....I don't think you want to cheap out on a header. :)

If it was easy to clean, it might be neat in terms of less waste, more eco friendly... :)

Thanks Nathan! :)

I don't know much about engines. I have a fairly stock 1998 SiR-G and I want to keep the engine well maintained. Car is 12 years old now so what needs to be done? Any advice welcome... 1. Do you have to pull the engine to change timing belt? 2. If so, would it make any sense to replace...

Is it burning it or leaking it?

Anyone ever heard of a reusable oil filter? Would you use one? http://www.jhpusa.com/store/pc/viewPrd.asp?idproduct=7006&idcategory=582

If it was just the tall factor, I would say some of the racing seats have super low seat rails, which should give you an extra inch or two height wise. Not sure about the width factor... What's your waist measurement?

Get the window film that is designed to stop shatter for the side windows. It will still break, but it won't shatter into little bits. On another note, setup a motion light and camera and use the evidence to put em in jail. :)

Well actually the wireless signal was picked up on public property on HIS laptop. If you found a dollar on the roadside, with no markings to say who the owner was, it's up for grabs. If you found a car on the road side, or a wallet, there are ownership markings all over, and that would be...

this video is for a RSX but it will give you an idea... http://www.youtube.com/watch?v=i4ru6Q3NTII heres on a DC2....look where he removes the stock OEM intake... http://www.youtube.com/watch?v=Vyk5eVrMTUA notice how the cold air intake pulls air from down low by the fender / near to the...

This is a short ram intake...but it's the same idea...look where it goes... A cold air reaches even further with the tubing..and bends down south where the filter is in this picture..

If you can get the vinyl in your desired color and DIY, then it's worth it by all means.

^^ So your looking at spending about $500-$1000 either way you look at it. Or you could spend under $200 on a Short Ram Intake alone...and install it yourself in less than an hour.

lip for sale? price shipped to FL? :P